Eve HoldingEVEX
Recorded

Eve Holding 2026 Q3 Earnings Call

Review the key takeaways and the transcript of this earnings call.

PeriodQ3 2026Duration46 minParticipants12

Transcript

Preview the first fifteen paragraphs, organized by speaker.

Operator

Good morning, and welcome to the Eve Holding Inc. Third Quarter 2026 Earnings Conference Call. All participants will be in listen-only mode. Should you need assistance, please signal a conference specialist by pressing the star key followed by zero. After today's presentation, there will be an opportunity to ask questions. To ask a question, you may press star then one on a touch-tone phone. To withdraw your question, please press star then two. Please note, this event is being recorded. I would now like to turn the call over to Lucio Aldworth, Head of IR. Please go ahead. Welcome to Eve's Third Quarter 2026 Earnings Conference Call.

Lucio AldworthHead of Investor Relations

Earlier today, we released our financial results for the quarter, which are available on our investor relations website. Joining me on today's call are Johann Bordais, Chief Executive Officer, and Eduardo Couto, Chief Financial Officer. During the call, Johann will provide an overview of our quarterly performance, strategic initiatives, and progress in our development process. Edu will then review our financial results in greater detail and discuss our outlook. Following our prepared remarks, we will open the call for questions, at which point Marcelo Basile, our Chief Flight Prototype Engineer, will join us to address more technical questions. Before we begin, please note that today's discussion may include forward-looking statements regarding future events, operating performance, and financial results.

Lucio AldworthHead of Investor Relations

These statements are based on current expectations and assumptions and are subject to risks and uncertainties that could cause actual results to differ materially. Additional information regarding these risks can be found in today's earnings release and our filings with the SEC. We will also discuss certain non-GAAP financial measures. Reconciliations of these measures to the most directly comparable GAAP measures are included in our earnings materials and are available on our investor relations website. Now, I'll turn it over to our CEO, Johann.

Johann BordaisCEO

Thank you, Lucio. Good morning, everyone, and welcome to our Third Quarter 2026 Conference Call. We had a good quarter with several milestones that clearly demonstrate consistent progress in the development of our eVTOL and the surrounding ecosystem. After the inaugural flight of our engineering prototype last December, we went through a series of hover flights. After we concluded the planned ground test period with software updates, we resumed our flight campaign with partial transition flights, where we started to engage the pusher with the lifters still powered on, and we gradually faster speed. That phase is now complete, and we plan on performing our first full transition flight by powering the lifter down before the end of the year. In parallel, we continue to test individual components in dedicated rigs as part of our building block approach.

Johann BordaisCEO

This multi-phase testing approach validates not only our design philosophy by extensively testing every part individually, but also the integration of critical systems such as fly-by-wire and fixed-pitch lifter rotors. We have also started to receive the first parts and components of the first of six prototypes we will assemble for our certification campaign. We have some additional pictures further in the presentation. Lastly, we signed a new binding agreement with Brazilian operator FlyBIS, who will serve the southern part of Brazil with our aircraft. Slide three and four show the progress of our flight campaign. With successful completion of our ground test, we cleared the prototype to get back in the air and start transition flights back in July. The prototype flew 73 times and logged a total of three hours and six minutes of airtime.

Johann BordaisCEO

The pusher was engaged at first with low RPMs and then powered up to around 1,200 RPMs, allowing the aircraft to fly forward at 45 knots, which is about 52 miles per hour. The next phase involves accelerating further towards the transition speed of around 100 knots. This is the speed at which air flowing through the wings is enough to provide it with the necessary lift and maintain airborne with the lifters' motors off. We are now eight to 10 flights away from the full transition phase. Slide four shows the progress we have made in the last few months in terms of speed, and perhaps more importantly, the engineering test points we have validated so far. Our aircraft never flies for the sake of flying. Our engineering team diligently plans the individual points that needs to be successfully validated for the aircraft to move to the next phase.

Johann BordaisCEO

These points may involve aircraft performance metrics, such as the aerodynamic drags or the loads or the performance of individual components, such as the rotor vibration, battery temperature, motor RPMs versus thrust, et cetera. It is precisely these validations that allow us to move ahead with confidence. As of today, we have successfully validated 170 of 185 planned test points for the engineering prototype flight test campaign, achieving a 91% completion. On slide five, we wanted to show you some additional details of our rigs we have put in place to test individually components separately. We can see here the one of the lifter motors running the last set of tests before shipping, and all lifters are on track for delivery and assembly of our certification prototypes. These tests confirm that each motor produced the necessary thrust for takeoff and landing procedures for the flight schedule.

Johann BordaisCEO

The rigs are used to corroborate the energy requirement and expected drain on the entire system, and that the inverter also successfully managed the flow of energy during the peak demand and the takeoff and landing phases of the flight. On top of that, we run successful containment of thermal runaway event on the battery pack. There are multiple ways to prevent thermal events via cells isolation, control of charging/discharging on a cell-by-cell basis, all of which are part of our aircraft design. But it must also be able to successfully contain a thermal event to assure the flight safety. On slide six and seven, we show some of the additional components and parts that have already been produced for our first conforming prototype. As you can see here, large fuselage sections, as well as tooling for wings and pylon structure are ready.

Johann BordaisCEO

We will start receiving these and other parts in the next few months to start the assembly of our first prototype early next year. The assembly of the subsequent five other prototypes will start right after delivering each of them 30 days after another to the Gavião Peixoto test facility. The next piloted prototype flight will take place by the second half of next year. Now, moving to slide eight and nine. As mentioned before, we just signed a new firm agreement with operator FlyBIS for a total of 12 aircraft, two firm orders and an option for additional 10, for a potential contract size of $60 million. FlyBIS is a regional operator in the south of Brazil with routes in region with a high touristic demand.

Johann BordaisCEO

Brazil represents a premier market for urban air mobility, driven by government and certification authority support, a rapidly maturing ecosystem, and strong passenger demand in cities where infrastructure has not kept the pace of growth. This makes Brazil one of the most important markets and positions it as among the first scale commercially following the certification, with two operators already committed and several more showing strong interest. This is a good entry point into the next slide, which shows our total pre-order backlog of approximately 2,500 aircraft valued at about $12.6 billion at list price. Additionally, approximately 1,100 of those aircraft have a service contract attached to them, bringing a total potential TechCare revenues to about half a billion dollars in the first year of operations.

Johann BordaisCEO

The next slide shows some of the SunTrax Ecosystem Summit in Florida, gathering 150 representatives of all of our future UAM operation stakeholders. The event, in partnership with the Florida Department of Transportation, provided insight into the infrastructure, operational procedures, and airspace navigation procedures needed to enable the safe and efficient integration of UAM into Florida transportation network. SunTrax advanced air mobility facilities include an aerial test track, vertiports, hangars, and charging infrastructure for simulated eVTOLs takeoff and landing, plus the low altitude corridor for drones, air taxis, and autonomous logistic test in a controlled regulated environment. Now, I hand it over to our CFO, Edu, for the third quarter of 2026 financial review.

Eduardo CoutoCFO

Thanks, Johann. On slide 11, Eve ended the third quarter 2026 with $356 million in cash and total liquidity of $471 million, which includes $114 million in undrawn standby credit loans. We believe the current level of liquidity is enough to support operations through 2028 without new funding. One important highlight during the quarter is that Eve has already started to show synergies and cost avoidance gains that were identified in the first half of this year. We have been working extensively with Embraer to find ways to reduce our cash burn until certification, with identified savings of $100 million-$150 million. Only in 2026, we already captured approximately $50 million of those savings, despite higher development activities and stronger engineering engagement. Eve's SG&A is going down year-over-year, and our total cash burn in the first nine months of 2026 was $174 million.

Eduardo CoutoCFO

With that, Eve's total cash consumption is now pointing towards the low end of our guidance of $225 million-$275 million in 2026, which is a reduction versus our initial forecast. The captured synergies are reducing our cash burn and extending Eve's cash runway without any impact in our vehicle development and certification timeline. Now moving to slide 12 with a summary of our financial results. Eve invested $48 million in R&D during the third quarter 2026, mainly for the eVTOL development. Meanwhile, SG&A totaled $6 million for the quarter, down from $7 million a year ago. Including R&D and SG&A, Eve's net loss for the third quarter 2026 was $58 million and $161 million in the first nine months of 2026.

Eduardo CoutoCFO

As mentioned previously, we ended the quarter with $356 million in cash and $471 million in total liquidity. Finally, cash consumption in the third quarter was $55 million and $174 million in the first nine months of 2026. With that, we conclude our remarks, and I would like to open the call for questions. Operator, please proceed. Thank you.

Operator

We will now begin the question-and-answer session. To ask a question, you may press star then one on your telephone keypad. If you are using a speakerphone, please pick up your handset before pressing the keys. If at any time your question has been addressed and you would like to withdraw your question, please press star then two. At this time, we will pause momentarily to assemble our roster. The first question comes from Andres Sheppard with Cantor Fitzgerald. Please go ahead. This meeting is being recorded.

FULL TRANSCRIPT

Continue the full translated transcript in StockNow.

Log in to unlock every statement, the English original, and speaker-by-speaker history.

Log in for the full transcript

Other earnings calls that day

View calls from this day